Buffers - Type Circular Rubber Mountings

Buffer or Bump Stops have been designed as deceleration devices to reduce the effects of impact forces.

Can be incorporated as a resilient stop that provides progressive stiffening to a suspension system under load.

All parts are manufactured using high quality natural rubber and are available in two compounds with nominal shore hardness of 45 and 60.

Standard sizes from 10 mm diameter by 10 mm thick to 100 mm diameter by 50 mm thick.

Special variants available (subject to Minimum Order Quantities).

Parts are manufactured with steel metals, zinc plated on exposed surfaces.

Buffers should not be exposed to contamination by mineral oils.

Application Notes:

Exposure to contamination by mineral oils will severely reduce working life.
Bolts are fully threaded to within two pitches of metal plates.
Nuts and washers are not supplied unless specially requested.
Isolator stiffness is linear up to maximum load therefore actual deflection is directly proportional to the load applied.